Glyn EVB Cellular PCB Starter Kit

• The kit can be used for non-cloud or cloud development. 
• Very ideal for IoT development that comes out of the box.
• Baseboard for PCIe  or GFF cards
• Available as EVB baseboard only or EVK kit with PCIe card/antennas

This kit includes depending the option chosen:

• The Base Board
• Mini PCIe Module with Standard 2FF SIM holder (see here for form factors)
• Trial SIM from Onomondo

Due to planned obsolescence of Molex 80-Way connector 0539490878 and mating connector 0541500878, refer to our  Part Change Notification. 

More Resources:

• For a Getting Started Guide see here
• For a Hardware guide see here
• mPCIe design package footprints / 3d model / EDA lib / edge connections see here
• Telit sim resource sheet
• Telit related services presentation
• Glyn news article of EVB with 5G news here
• Part Change Notification (Connector) see here
• Active GNSS Antenna - see here

Related Products

• Telit deviceWISE IoT cloud see here
• Telit services overview
• Attend PCIe connectors  see here
• Glyn mPCIe cards  see here
• Antenova SMD antenna chips for 3G/4G/5G  see here
• 4G LTE AND MIMO: MITIS FLEXIBLE ANTENNA see here

Recommendations:

• Attend PCIe connectors page here
• MPS power supply IC's with built in inductor as used in Alto kit...see schematics in the manual above.   See power supply recommendations

Glyn PCIe card page

IMPORTANT NOTE - this kit has been designed to be a low cost introduction to Telit Cellular Modules and IOT connectivity platform. It is NOT designed for mass production or industrial deployment.

Please also ensure that you don't use a USB cable longer than 30cm. Due to voltage drop over the cable, any inferior quality or longer length cable may cause intermittent problems when connecting to the network when there is peak 2A short burst requirements.