Glyn EVB Cellular PCB Starter Kit

• The kit can be used for non-cloud or cloud development. 
• Very ideal for IoT development that comes out of the box.
• Baseboard for PCIe  or GFF cards or Xbee cards
• Available as EVB baseboard only or EVK kit with PCIe card/antennas

This kit includes:

• The Base Board
• Trial SIM from Onomondo

More Resources:

• For a Quick Start Guide see here
• For a Hardware guide see here
• mPCIe design package footprints / 3d model / EDA lib / edge connections see here
• Glyn news article of EVB with 5G news here
• Part Change Notification (Connector) see here
• Active GNSS Antenna - see here

Related Products

• Attend PCIe connectors  see here
• Glyn mPCIe cards  see here
• Antenova SMD antenna chips for 3G/4G/5G  see here
• 4G LTE AND MIMO: MITIS FLEXIBLE ANTENNA see here

Recommendations:

• Attend PCIe connectors page here
• MPS power supply IC's with built in inductor as used in Alto kit...see schematics in the manual above.   See power supply recommendations

Glyn PCIe card page

IMPORTANT NOTE - this kit has been designed to be a low cost introduction to Telit Cellular Modules and IOT connectivity platform. It is NOT designed for mass production or industrial deployment.

Please also ensure that you don't use a USB cable longer than 30cm. Due to voltage drop over the cable, any inferior quality or longer length cable may cause intermittent problems when connecting to the network when there is peak 2A short burst requirements.